28" Standard Clamp

28" Standard Line Clamp

Features:

Designed for use on 28” pipe
Cam style (aka hand lever or toggle) clamps are quick and efficient pipe clamps
Hydraulic style clamps use a hydraulic mechanism to secure the clamp to the pipe joint
Standard line clamps are a cost effective alternative to the Classic Ratchet Line clamps
Clamps will align up to schedule 80 pipe
Ring spacing enables easy access to pipe joint
Available No Tack Pads are arched away from the pipe, enabling better access to the weld joint and increasing weld efficiency
Available Stainless Steel Pads for welding on stainless steel or specialty pipe
Clamp inside diameter is sized 1/8" larger than nominal pipe diameter
Note: hydraulic jack should only be operarted while in the vertical postions
Before use, read WARNING below

Request Quote

Clamp Type:	CAM/TOGGLE
Part #:	KCS-28-C
Weight:	141 lbs (64 kg)
Clamp Material:	Carbon Steel
Hydraulic Jack Rating:	N/A
No-Tack Pads Option Part #:	KCS-28-C-NT
Stainless Pads Option Part #:	KCS-28-C-SS

Clamp Type:	HYDRAULIC
Part #:	KCS-28-H
Weight:	174 lbs (79 kg)
Clamp Material:	Carbon Steel
Hydraulic Jack Rating:	24,000lb (12T)
No-Tack Pads Option Part #:	KCS-28-H-NT
Stainless Pads Option Part #:	KCS-28-H-SS

Catalog Cut Sheet

WARNING! 1. Do not use the alignment clamp as a lifting device. 2. K.C. alignment clamps are not to be used as a load bearing device. 3. A lift mechanism should not be attached to the clamp to lift the pipe. 4. Wedges should not be driven under the frame of the clamp in an attempt to reform the pipe as it may damage the clamp and void the warranty. 5. The clamp is not designed for the alignment of the tees, elbows, valves and other fittings. 6. The clamp should not be used with any type of device that is used to preheat the pipe prior to welding as this may result in failure of the clamp. 7. Do not use a mechanical advantage (such as a cheater bar) on the end of the cam or hydraulic jack handle.